|
|
|
Who's Online
There currently are 5675 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
;
excellent value & price! Includes everything you need to know about the NN-C777! I would buy this again.
;
Very satisfied! I was searching for several days, but nope; till I discovered your webside and there it was at a very reasonable price. Keep up the good work!
Paul
Flanders
 ;
Generally speaking good copy; a few pages too hard contrast...
Good service and communication.
;
I purchased the unit from a private party and the original owners manual was not available. Having the ability to download it was extremely helpful and clarified operating the equipment immensely. This is a complicated unit and without the manual I would not have been able to maximize it's potential. Thank you.
ASSEMBLY
Assembling the spray guard and trimmer head Superauto II
(322L, 323L, 323LD, 325LX, 325LXT, 325LDX)
� Fit the guard (A) intended for use with the trimmer head. Hook the guard onto the shaft fitting and secure it with the bolt (L). � Fit the drive disc (B) on the output shaft. � Turn the blade shaft until one of the holes in the drive disc aligns with the hole in the gear housing. � Insert the locking pin (C) in the hole so that the shaft is locked. � The trimmer head must be split to be fitted (see the diagram). Proceed as follows: � Insert your finger into the centre hole of the cover (I) at the same time as you hold the cover with your other fingers. Press the two catches (J) that extend from the cut-out on the bottom section (K) using the thumb and index finger of your other hand. Press apart the trimmer head using the fingers on the cover. � Place the cover (I) and the support flange (F) on the output shaft. � Fit the nut (G). The tightening torque of the nut is 35-50 Nm (3,5-5 kpm). Use the socket spanner in the tool kit. Hold the handle of the spanner as close to the trimmer guard as possible. The nut is tightened when the spanner is turned against the direction of rotation (left-hand thread). � Fit the trimmer head�s bottom section (K) on the cover (I) by pressing the two sections together with the cut-outs on the bottom section aligned with the catches on the cover. � To dismantle follow the instructions in the reverse order.
A J K I
Assembling other guards and cutting equipment
(322L, 323L, 323LD, 325LX, 325LXT, 325LDX)
� Fit the guard (A) intended for use with the trimmer head. Hook the guard onto the shaft fitting and secure it with the bolt (L).
� Fit the disc drive (B) on the output shaft. � Turn the blade shaft until one of the disc drive�s holes aligns with the corresponding hole in the gear housing.
H
� Insert the locking pin (C) into the hole to lock the shaft.
K
G F I
� Screw on the trimmer head (H) in the direction of rotation.
B C
� Dismantling takes place in the reverse order.
Fitting the spray guard and trimmer head (322C, 323C)
Guard � Fit the guard as shown in the diagram. Tighten securely. Trimmer head � Fit the dust cup on the shaft. The nut must be completely covered by the dust cup. � Hold the dust cup with a spanner to prevent the shaft from rotating. � Screw the trimmer head onto the shaft.
English �
13
|
|
|
> |
|
