|
Who's Online
There currently are 5957 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Absolutely perfect! I've been trying to understand how to use all or at least some of the features of the receiver and especially the remote.
;
Copy of genuine owners/operators manual, very useful
;
The manual was a perfect match and was exactly what I was looking for. I'm very satisfied with my purchase.
;
Thank you for having the manual I needed for an older model Aiwa stero I had found on Ebay --- I wanted the Aiwa because I had tapes and cd's but I did not have a manual as to how to operate the system... I found what I needed and it has enabled me to set the system up for my enjoyment.
;
I wished detailed information of the JBL S310 and here I found it! Very happy with the service from this site!
ASSEMBLY
Fitting a trimmer guard and Superauto II 1� trimmer head
(323L, 323LD, 325Lx, 325LDx)
Fitting other guards and cutting attachments
(323L, 323LD, 325Lx, 325LDx)
K
�
Fit the correct trimmer guard (A) for use with the trimmer head. Hook the trimmer guard/combination guard onto the �tting on the shaft and secure with the bolt (L).
K J I
G F I
B C
A
�
Fit the correct trimmer guard (A) for use with the trimmer head. Hook the guard onto the �tting on the shaft and secure it with the bolt (L). Fit the drive disc (B) on the output shaft. Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing. Insert the locking pin (C) in the hole to lock the shaft. To �t the trimmer head, �rst separate the two halves (see diagram). Proceed as follows: Insert a �nger into the centre hole of the cover (I) while grasping the cover with your other �ngers. Using the index �nger and thumb of your other hand, release the two catches (J) that engage in the cut-outs in the bottom half (K). Pull apart the trimmer head, grasping the cover �rmly. Place the cover (I) and the support �ange (F) on the output shaft. Fit the nut (G). The nut must be tightened to a torque of 35-50 Nm (3.5-5 kpm). Use the socket spanner in the tool kit. Hold the shaft of the spanner as close to the blade guard as possible. To tighten the nut, turn the spanner in the opposite direction to the direction of rotation (Caution! left-hand thread).
� � � �
Fit the drive disc (B) on the output shaft. Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing. Insert the locking pin (C) in the hole to lock the shaft. Screw on the trimmer head/plastic blades (H) in the opposite direction to the direction of rotation.
H
� � � � �
H
� �
�
To dismantle, follow the instructions in the reverse order.
Fitting the trimmer guard and trimmer head
(323C)
Guard
� Fit the guard as shown in the diagram. Tighten securely.
�
Fit the bottom half of the trimmer head (K) to the cover (I) by pressing them together, with the cut-outs on the bottom half aligned with the catches on the cover.
Trimmer head
� � � To dismantle, follow the instructions in the reverse order. � Fit the dust cup on the shaft. The nut must be completely covered by the dust cup. Hold the dust cup with a spanner to prevent the shaft from rotating. Screw the trimmer head onto the shaft.
English
� 11
|
|
|
> |
|