My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
This manual is very helpfull to use the Power Supply. All technical information has been available.
For service use the circuit diagrams are very good.
Thanks .
Very comprehensive document which is a must-have for any Satellit 2100 owner whose set up is somewhat intricate. Due to the bad quality of the pictures that are rather dark and a bit blurred I gave 4-star feedback.
The manual was missing 2 pages but when I presented the problem to the company they made every attempt to get the 2 pages to me, when they couldn't they refunded my money. A very pleasing and easy transaction. The manual they provided was the original, it was concise and to the point. I plan to do business with this company again when should the need arise.
The owners manual is very good. all my how to questions were answered in detail.
Text excerpt from page 14 (click to view)
ASSEMBLY
Fitting the cutting head
� When �tting a new chain, the chain tension has to be checked frequently until the chain is run-in. Check the chain tension regularly. A correctly tensioned chain ensures good cutting performance and long life.
� � �
Fit the cutting head on the shaft so that the screw (A) is aligned with the hole in the shaft as shown. Tighten screw A. Tighten screw B.
Adjusting the harness
B
You should always use the harness with the machine to give maximum control over the machine and reduce the risk of fatigue in your arms and back. � Put on the harness. Hook the machine onto the harness support hook. Adjust the length of the harness so that the support hook is roughly level with your right hip.
A
CAUTION! Make sure that the drive shaft inside the shaft engages with the cut-out in the cutting head.
� �
Fitting the bar and chain
Unscrew the bar nut and remove the protective cover. Fit the bar over the bar bolt. Place the bar in its rearmost position. Place the chain over the drive sprocket and in the groove on the bar. Begin on the top side of the bar. Make sure that the edges of the cutting links are facing forward on the top edge of the bar. Fit the cover and locate the chain adjuster pin (A) in the hole in the bar. Check that the drive links of the chain �t correctly on the drive sprocket (B) and that the chain is in the groove in the bar (C). Tighten the bar nut �nger-tight.
Filling with oil
�
Open the cap on top of the bar head
� Tension the chain by turning the chain tensioning screw clockwise. Use a combination spanner or turn by hand. The chain should be tensioned until it �ts snugly on the underside of the bar. �
Fill with Husqvarna saw chain oil. Re�t the cap.
Assembling and dismantling the two-piece shaft (325P5)
Assembly:
� � The chain is correctly tensioned when there is no slack on the underside of the bar, and it can still be turned easily by hand. Tighten the bar nut with the combination spanner while holding up the tip of the bar. � Make sure the knob is loose. Align the cut-out in the upper shaft with the coupling's lock plate on the lower shaft. The parts then lock together.
