Last week I bought a second hand BAUKNECHT TRK4850 DRYER. It is a professional machine with many programs and switch options. I feared it would be a huge quest to find a manual. I was delighted when I found owner-manuals.com. After payment I received the file to download the next day already. The quality is great. I am very happy. Thanks!
but kindly the distributions of the operating programs not find in the owners manual,can you help me to understand the operating programs instructions thank you
Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
Text excerpt from page 29 (click to view)
Checking the drive belt 1. Allow the engine to cool. 2. Remove the spark plug cable. 3. Remove the belt guard (see illustration) on the left side of the machine. 4. Check that the belt is running in the proper track; the pulleys should guide the belt in a straight line. 5. Check that the belt and pulleys are not oily. If they are, first try to clean them with spirits. If they are heavily coated, take the machine to an authorized service workshop to fix the oil leakage and replace the belt. 6. Check the belt for cracks, heat damage or worn edges. If these symptoms appear, replace the drive belt; see â€¯Replacing the drive beltâ€¯. 7. Check that guide and tensioning equipment for the belt is not loose and is properly set; see â€¯Replacing the drive beltâ€¯. 8. Refit the belt guard. Replacing the drive belt Replace the drive belt as follows: 1. Allow the engine to cool. 2. Remove the spark plug cable. 3. Remove the belt guard. 4. Remove the old belt. 5. Check for wear on the pulleys and replace as necessary. 6. Check the pulley setting against the rotor pulley and adjust as necessary. The belt should run in the track. 7. Check the tensioning pulley. The bearings should rotate freely and evenly. The rocking lever on the tensioning pulley should be free with a lateral play of not more than 6.5 mm (0.25") (see illustration). Replace as necessary. 8. Fit a new belt by first pulling it over the lower pulley and then the engine pulley. Check that the tensioning pulley and belt guides end up outside the belt loop. 9. Adjust the belt guides as necessary and refit the belt guard.
8011-245 DT07 DT06 8011-027