|
Who's Online
There currently are 5855 guests and 1 member online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Thank´s for your help, I already recived these manual from you
;
Thank you for your manual It has the basic things to and i use the Oszi for Longer Time.
THX
;
Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
;
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
;
Good list of manuals. I found a very rare one and easily get. Should be promptly to download, as we must to wait hours even after confirmed payment.
SERVICE AND ADJUSTMENTS
FRONT WHEEL CAMBER
The front wheel camber is not adjustable on your tractor. If damage has occurred to affect the front wheel camber, contact your nearest authorized service center/department.
WASHERS RETAINING RING AXLE COVER
B
FRONT OF TRACTOR
FIG. 30
A
FIG. 28
ADJUSTMENT SLEEVES TIE ROD
TO START ENGINE WITH A WEAK BATTERY (See Fig. 31)
WARNING: Lead-acid batteries generate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries. If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the Customer Responsibilities section of this manual). If �jumper cables� are used for emergency starting, follow this procedure:
IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.
JAM NUTS
FIG. 29
TO REMOVE WHEEL FOR REPAIRS
FRONT WHEEL (See Fig. 30) � Block up axle securely. � Remove axle cover, retaining ring and washers to allow wheel removal. � Repair tire and reassemble. � Replace washers and snap retaining ring securely in axle groove. � Replace axle cover. REAR WHEEL � � � Block rear axle securely. Remove five (5) hub bolts to allow wheel removal. Repair tire and reassemble. Replace and tighten hub bolts securely. NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.
TO ATTACH JUMPER CABLES � Connect one end of the RED cable to the POSITIVE (+) terminal of each battery(A-B), taking care not to short against tractor chassis. � Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery. � Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery. TO REMOVE CABLES, REVERSE ORDER � BLACK cable first from chassis and then from the fully charged battery. � RED cable last from both batteries.
WEAK OR DEAD BATTERY
FULLY CHARGED BATTERY
FIG. 31
24
|
|
|
> |
|