|
Who's Online
There currently are 5758 guests and 1 member online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Very well done!!!!! congratulations. It was a bit longer than usual the wiating time even if it was on time (in 24 hours).
;
Last week I bought a second hand BAUKNECHT TRK4850 DRYER. It is a professional machine with many programs and switch options. I feared it would be a huge quest to find a manual. I was delighted when I found owner-manuals.com. After payment I received the file to download the next day already. The quality is great. I am very happy. Thanks!
but kindly the distributions of the operating programs not find in the owners manual,can you help me to understand the operating programs instructions thank you
;
Very good copy, very readable and easy transaction as always.
;
It is perfect, exactly what we needed. It's like the paper version but less clutter.
;
Received my manual within 24 hours. Very clear scan of the manual I needed. Thanks!
SERVICE AND ADJUSTMENTS
� � Place �at washer and clutch spring on idler pulley bolt and secure with small retainer spring. Install belt onto engine pulley. FRONT-TO-BACK ADJUSTMENT (See Figs. 17 and 18)
IMPORTANT: DECK MUST BE LEVEL SIDE-TO-SIDE. IF THE FOLLOWING FRONT-TO-BACK ADJUSTMENT IS NECESSARY, BE SURE TO ADJUST BOTH FRONT LINKS EQUALLY SO MOWER WILL STAY LEVEL SIDE-TO-SIDE.
TO LEVEL MOWER HOUSING
Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly in�ated (See �PRODUCT SPECIFICATIONS� section of this manual). If tires are over or underin�ated, you will not properly adjust your mower. SIDE-TO-SIDE ADJUSTMENT (See Figs. 15 and 16) � Raise mower to its highest position. � At the midpoint of both sides of mower, measure height from bottom edge of mower to ground. Distance �A� on both sides of mower should be the same or within 1/4" of each other. � If adjustment is necessary, make adjustment on one side of mower only. � To raise one side of mower, tighten lift link adjustment nut on that side. � To lower one side of mower, loosen lift link adjustment nut on that side. NOTE: Three full turns of adjustment nut will change mower height about 1/8". � Recheck measurements after adjusting.
BOTTOM EDGE OF MOWER TO GROUND
00598
To obtain the best cutting results, the mower housing should be adjusted so that the front is approximately 1/8" to 1/2" lower than the rear when the mower is in its highest position. Check adjustment on right side of tractor. Measure distance �D� directly in front and behind the mandrel at bottom edge of mower housing as shown. � Before making any necessary adjustments, check that both front links are equal in length. � If links are not equal in length, adjust one link to same length as other link. � � � To lower front of mower loosen nut �E� on both front links an equal number of turns. When distance �D� is 1/8" to 1/2" lower at front than rear, tighten nuts �F� against trunnion on both front links. To raise front of mower, loosen nut �F� from trunnion on both front links. Tighten nut �E� on both front links an equal number of turns. The two front links must remain equal in length. When distance �D� is 1/8" to 1/2" lower at front than rear, tighten nut �F� against trunnion on both front links. Recheck side-to-side adjustment.
MANDREL
01268
� �
BOTTOM EDGE OF MOWER TO GROUND
�A�
GROUND LINE
�A�
"D" "D"
FIG. 15
SUSPENSION ARM
FIG. 17
BOTH FRONT LINKS MUST BE EQUAL IN LENGTH
01553
LIFT LINK ADJUSTMENT NUT
01267
FIG. 16
NUT "F" TRUNNION
01156
NUT "E"
FRONT LINKS
FIG. 18
19
|
|
|
> |
|