I found my Clarion VRX8370R in the Camper I bought and I wasn't able for month to understand it.
The Owner Manual was perfect and just what I was searching for.
Thank you.
Leonardo
I AM HIGHLY IMPRESSED BY THE EASE OF USE OF THIS DOWNLOAD SERVICE. INSTRUCTIONS ARE CLEAR AND SIMPLE TO FOLLOW....EVEN BY TECHNOPHOBES SUCH AS MYSELF. THE EMAILS POINT YOU IN THE RIGHT DIRECTION...ITS SO EASY PEASY. THE DOWNLOAD CHOICE OF USER MANUALS IS EXTENSIVE AND I COULD NOT FIND A CHEAPER OR MORE EFFICIENT SERVICE ON THE INTERNET. I COULD NOT HAVE MADE A BETTER CHOICE OF INFORMATION PROVIDER. SHOULD I EVER NEED ANOTHER USER MANUAL, THEN THIS IS THE FIRST CHOICE SITE. COULD NOT BE BETTER PLEASED!!!!!!!...MANY THANXES FROM JIM BURNS
Text excerpt from page 31 (click to view)
MAINTENANCE
Adjustment of the cutting unit�s parallelism for the Rider 11 Bio and Rider 13 Bio
1. Check the tyre air pressure. It should be 60 kPa (0,6 kp/cm2). 2. Dismantle the front hood and right-hand fender as described on page 20-21. 3. Vertical adjustment of the cutting unit is made with the adjusting nuts on the back edge of the lift-strut. 4. Raise the cutting unit at the front edge by shortening the lift-strut. Lower the cutting unit at the front edge by lengthening the lift-strut. 5. Tighten the nuts against each other after the adjustment. 6. On completion of the adjustment the unit�s parallelism should be re-checked. Fit the right-hand fender and the front hood.
2
Adjusting the alignment of the cutting unit for the Rider 11 Bio and Rider 13 Bio
1. Check the tyre air pressure. It should be 60 kPa (0,6 kp/cm2). 2. Remove the front hood and right-hand fender as described on page 20-21. 3. Unscrew the nut (1) from the parallel strut. Remove the clip (2) and the parallel strut. 4. Turn the fork anti-clockwise to lower the rear edge of the hood, or clockwise to raise the rear edge of the hood. 5. Once adjustment is complete, refit the parallel strut and clip and tighten the nut. 6. Recheck the alignment of the cutting unit after adjustment. 7. Refit the right-hand fender and hood.