Manual was delivered in a timely manner and was all in English as advertised. The manuals I received when we moved into our flat were in German, Italian, and French. Having never used a steamer before, and not speaking/reading German very well, I needed an English Manual. this was a huge help.
This GRUNDIG UV5A Owner Manual is not only an instruction manual but a total functional circuit description of the Multimeter and includes circuit diagram at the end pages. It is very helpful for repairing and calibrating the instrument. It is written in two languages English and German for international support. It was very easy to repair my unit with this document. Regards, Regis Pauly, Electrical Engineer.
The owner's manual was evetything I thought it would be. I was able to print it out using both sides of the paper in quick order, saving me a search online for a used one.
Text excerpt from page 35 (click to view)
IMPORTANT INFORMATION The blades on a BioClip unit should be set at 90 degrees to each other. In all other cases the blades can collide and cause serious damage to the cutting unit. 5. Ensure the blades are positioned as set out in the diagram, at 90 degrees to each other, otherwise the belt must be adjusted. When the blade bearings are loose the belt can be moved around to the next tooth. Tighten the nuts enough so that the bearings rest against the cutting hood but still can be moved. Tension the belt by turning the eccentric adjuster on top of the cutting hood. Tighten the nut. Tighten all nuts on the blade bearings. 6. When the belt can be moved 8 mm (5/16") inwards using a force of 7 N (1.5 lb) the belt is adjusted correctly. 7. Fit the protective cover over the belts and replace the parall strut.
Belt replacement on the Combi 103, 112 cutting unit WARNING! Wear gloves to protect your hands when working with the blades. On these cutting units with â€ścollision-proofâ€ť blades, the blades are driven by one V-belt. Do as follows to change the V-belt: 1. Remove the cutting unit. 2. Undo the bolt on the lift strut and the two screws on the cover. Lift the cover off the cutting unit. 3. Loosen the spring (4) that tensions the V-belt and pry off the belt. Simply reverse the procedure to fit the new belt.