5 star quality on these downloadable manuals. Easy to read and all the information is there. A must when doing a custom install or needing to service your precious old school electronics.
very helpful, the information in these manuels are very detailed
Text excerpt from page 26 (click to view)
RUNNING
5. 6. Hold in the the dead man�s grip bar and start the engine. Allow the engine to warm up for two minutes at idle before grinding.
8011-185 8011-127
7.
Tilt the machine on its wheels, lifting the cutting wheel off the ground/tree stump.
8011-202
8.
Set the throttle to ENGAGE.
8011-194
IMPORTANT INFORMATION If the cutting wheel is too low, the machine may start to �climb� over the stump and become instable. 9. Place the middle of the cutting wheel approximately 2.5 cm above and 2�4 cm into the stump.
8011-203
10. Place the cutting wheel in the upper front edge of the stump. Swing the cutting wheel from side to side while lowering it about 2.5 cm after each pass until the front edge of the stump is gone. 24 � English
